Camera port cover
If the booth camera isn’t used, close the port with the cover. It protects the assembly from dust and hands and keeps the front panel tidy. Installation takes under a minute and needs no tools.
When to install it:
- Interactive “Fortune Teller” mode — the screen runs without photo capture.
- Content sharing kiosk — the booth works as a terminal with no camera.
- Transport and storage — the port is closed, the assembly protected.
What’s in the box
Section titled “What’s in the box”- ×1 Plug (cross brace and thread)
- ×1 Ring (threaded collar)
- ✓ No tools required
Installation
Section titled “Installation”1. Clear the camera port
Section titled “1. Clear the camera port”If a camera on the swivel mount is installed, remove it and put it aside. The port must be clear.
2. Insert the plug from the front
Section titled “2. Insert the plug from the front”Insert the plug into the port from the outside, matte side out — it should sit flush with the panel.
3. Thread the ring on from inside
Section titled “3. Thread the ring on from inside”Holding the plug from the outside, thread the ring onto the plug from inside the booth — straight, without cross-threading.
4. Hand-tighten and check
Section titled “4. Hand-tighten and check”Tighten the ring by hand, no tools. The plug doesn’t rotate and sits flush on the outside.
The booth is ready to run in camera-free mode. To bring the camera back, remove the cover in reverse order.